|
Do it yourself
| |||
| ||||
Model: Kawasaki Z 650
In this video tutorial, you will learn how to remove the ECU on a Kawasaki Z 650 by following these simple steps. First, remove the side plastic fairings of your bike by unscrewing all the fixing screws with a Torx screwdriver; once removed, proceed to remove the fuel tank by unscrewing the lower and upper screws. At this point, disconnect the fuel line and the electrical connector of the fuel level sensor, then disconnect the electrical cables of your ECU to remove it, as shown in the video!
Updated on 9 April 2026 by ScegliAuto
Video tutorial
Related tutorials
Z 650
Today, let's go over the instructions on how to replace the engine coolant in the Kawasaki Z 650 motorcycle. First, we place the motorcycle on a stan…
Z 650
The fuses on the Kawasaki Z 650 are located inside the designated fuse box installed on the motorcycle. To access it, you will need to loosen the bol…
Z 650
This video provides instructions for removing the fuel tank on a Kawasaki Z 650. First, remove the screws located on the tank's panel using a spanner…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |