Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Kia
    3. :
  3. Sorento
    4. : How to replace the rear bulbs in the KIA Sorento?

Kia Sorento - Video tutorial

Model: Kia Sorento MK 3 - Years 2014-2020
Part: Tail light
Operation: How to replace the rear bulbs in the KIA Sorento?

In case we need to remove the rear light of the KIA Sorento, for example to replace one or more bulbs, we can follow this tutorial that shows us step by step how to do it. We only need a 10mm wrench and a flat tip screwdriver. We locate the small side door near the headlight inside the luggage compartment, open it with the help of the screwdriver and remove the two 10mm nuts. Moving outside, we pull the lighthouse towards us so that the two pins come out of their seat, as shown in the video. At this point, once the connector has been disconnected, we can proceed to replace the bulbs.


Posted on 8 March 2024 by ScegliAuto



How to change Kia Sorento headlight bulbs
Kia Sorento (2002-2009 / MK 1) Do we want to replace the rear light of the Kia Sorento? We remove the rear light from inside its body. Lift the tailgate of the luggage compartment
How to replace the headlight bulbs on the Kia Sorento Mk1
Kia Sorento (2002-2009 / MK 1) The guide shows how to replace the headlight bulbs of the Kia Sorento Mk1. To perform this operation it is necessary to use a 10 mm socket wrench to
How to replace the front headlight of the Kia Sorento.
Kia Sorento (2009-2014 / MK 2) Below we will see the instructions that will allow us to dismantle and replace the front headlight of the Kia Sorento, following these simple steps.

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos