Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the levers of the KTM EXC 250?

Model: Ktm Exc 250
Part:

Video tutorial

In order to replace the brake and clutch levers of the KTM EXC 250, you will need to loosen the screws that secure them to their housing: once the lever mounting screws have been removed, you can also loosen the nuts that secure the brake and clutch cables to the corresponding levers.

At this point, you can remove the old levers completely, connecting the new ones to the cables: once the connection is made, you can then position the new levers on the sides of the handlebars, securing them in place and checking that everything works properly.


Posted on 16 November 2025 by ScegliAuto


Related tutorials

How to replace the front brake pads on the KTM EXC 250?
How to replace the front brake pads on the KTM EXC 250?
Exc 250 To replace the front brake pads on the KTM EXC 250, loosen the bolts that secure the brake caliper to the corresponding disc: once the securing bolts…
How to Replace the Forks on the KTM EXC 250
How to Replace the Forks on the KTM EXC 250
Exc 250 To remove the forks from the KTM EXC 250, loosen the bolts securing them from the top: these bolts are located just below the handlebars. Once these …
How to Replace the Front Wheel on a KTM Exc 250
How to Replace the Front Wheel on a KTM Exc 250
Exc 250 The following steps will guide you through removing and replacing the front wheel on the KTM Exc 250 enduro bike, as well as the Exc 300 and Exc 125 …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos