Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you disassemble the engine of the KTM SX-F 350?

Model: Ktm Sx F 350
Part: Engine

Video tutorial

To disassemble the engine of the KTM SX-F 350, you need to loosen the screws that secure the engine block to its housing in the center of the frame. This will also allow you to loosen the screws that secure the exhaust headers and disconnect all the connectors of the relevant sensors.

By doing this, you can open the engine by loosening the screws that secure the cylinder and completely removing it. This will give you access to the piston, allowing you to detach it from the connecting rod. By doing so, you will have access to the crankshaft so that all necessary components can be replaced.


Posted on 29 November 2025 by ScegliAuto


Related tutorials

How to Dismantle the Cylinder Head Assembly on the KTM SX-F 350
How to Dismantle the Cylinder Head Assembly on the KTM SX-F 350
Sx F 350 .. of the head, cylinder, and piston, on the KTM SX-F 350 enduro bike. The dismantling operation can occur with the engine installed; however, for simplicity,.. …
How to Replace the Coolant in the KTM SX-F 350
How to Replace the Coolant in the KTM SX-F 350
Sx F 350 .. for replacing the coolant in the KTM SX-F 350 enduro bike. First, remove the plastic fairing on the right by unscrewing the fixing screws; then.. …
Replace the Engine Oil and Oil Filter of the Ktm SX-F 350
Replace the Engine Oil and Oil Filter of the Ktm SX-F 350
Sx F 350 .. the routine maintenance service on the Ktm SX-F 350 enduro bike. First, remove the oil drain bolt located under the engine and allow the oil to drain.. …

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos