Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Tyre on the KTM EXC 300

Model: Ktm Exc 300
Part: Tires

Video tutorial

In this guide, you will learn the main instructions on how to remove and replace the front tyre on the KTM EXC 300 enduro bike. First, place the bike on a stand and start by unscrewing the bolts of the front brake caliper, removing it from the disc; then, slide out the wheel axle to remove the wheel from the forks as shown in the video.

At this point, release the air from the tyre using levers to remove it from the rim; replace the tyre with the new one, securing it correctly and refitting the wheel onto the front forks!


Posted on 19 April 2026 by ScegliAuto


Related tutorials

How to Replace the Front Brake Pads on a KTM EXC-300
How to Replace the Front Brake Pads on a KTM EXC-300
Exc 300 To replace the front brake pads on a KTM EXC-300, remove the small clip that secures the pin holding the pads and caliper. Once the clip and pin are …
How do you disassemble the engine of the KTM EXC 300?
How do you disassemble the engine of the KTM EXC 300?
Exc 300 In order to disassemble the engine of the KTM EXC 300, you need to loosen the screws that fix the piece to its housing in the central lower part of t…
Engine Oil Change on a KTM 300 EXC
Engine Oil Change on a KTM 300 EXC
Exc 300 In this video tutorial, you will see how to perform the routine maintenance oil change on a KTM 300 EXC. First, remove the skid plate by unscrewing t…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos