Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Clutch replacement on a KTM 65

Model: Ktm 65
Part: Clutch

Video tutorial

Warm up the bike for a few minutes and drain the old engine oil. Remove the brake lever and the top cover of the clutch. Without the casing, you can now loosen the six small screws and then the central 17 mm bolt.

Once the clutch is removed, take out the pressure plate and the six springs related to the screws you just unscrewed. Lubricate the discs very well before reinserting them, soaking them in oil. Reassemble the clutch, then fit the discs, pressure plate, and springs (screw in the bolts).

Slot it back in place and tighten the 17 mm nut. Close the casing and add new engine oil.


Updated on 5 April 2026 by ScegliAuto


Related tutorials

How to Install the Clutch on a KTM EXC 525
How to Install the Clutch on a KTM EXC 525
Exc 525 Today, we will see, in this video tutorial, how to install the clutch discs and bell on a KTM EXC 525, following the instructions below. First, clean…
How to Replace the Clutch on a KTM SX-F 450?
How to Replace the Clutch on a KTM SX-F 450?
Sx F 450 To replace the clutch on the KTM SX-F 450, loosen the screws securing the clutch cover located on the right side of the bike. Once the screws are loo…
Replacing the Clutch on a KTM Exc 125 - 250
Replacing the Clutch on a KTM Exc 125 - 250
Exc 250 Today's guide will show you the main steps to remove and replace the clutch discs on the KTM Exc 125 and 250 enduro bike. First, unscrew the screws o…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos