Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the Front Headlight Bulb on the KTM RC 390

Model: Ktm Rc 390
Part: Headlight bulb

Video tutorial

In this video tutorial, we will go through the main steps to remove and replace the front headlight bulb on the KTM RC 390 motorcycle. First, remove the front plastic fairing to access the rear of the headlight.

Then, disconnect the electrical connector of the bulb, finally removing the bulb itself, as shown in the video. At this point, replace the bulb with a new one of the correct type and with the same fitting (in this case, a new LED bulb is installed); securely attach the connector to the front headlight!


Updated on 15 May 2026 by ScegliAuto


Related tutorials

How to Replace the Headlight Bulbs on a KTM RC 390?
How to Replace the Headlight Bulbs on a KTM RC 390?
Rc 390 In this tutorial, you can see how to replace the headlight bulbs on a KTM RC 390, a very simple and quick operation. First, ensure that the key is no…
How to Replace the Front Headlight Bulbs on a KTM RC 390
How to Replace the Front Headlight Bulbs on a KTM RC 390
Rc 390 In this tutorial, you will learn how to replace the front headlight bulbs on a KTM RC 390, a very simple and quick operation. First, ensure that the …
How to Replace the Front Brake Pads on the KTM RC 390?
How to Replace the Front Brake Pads on the KTM RC 390?
Rc 390 In this tutorial, you will learn how to replace the front brake pads on the KTM RC 390, a task that is extremely simple and quick. First, position yo…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos