Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Ktm
    3. : Xc W 500

How to Remove the Fuel Pump from the KTM XC W 500

Model: Ktm Xc W 500
Part: Fuel pump

Video tutorial

In this guide, you will find the main instructions that will allow you to remove and replace the fuel pump of the KTM XC W 500 enduro motorcycle. First, place your motorcycle on a stand and begin by removing the rider's seat; then unscrew the fastening screws of the fairings to subsequently remove the fuel tank, disconnecting the electrical connector and the fuel hose, as shown in the video.

At this point, unscrew the screws of the immersion fuel pump, removing it from the tank and replacing it with the new one!


Updated on 23 June 2026 by ScegliAuto


Related tutorials

Replacing the Fuel Pump on a KTM RC 200
Replacing the Fuel Pump on a KTM RC 200
Rc 200 Follow these brief steps to remove and replace the fuel pump on a KTM RC 200 motorcycle. First, place the bike on a stand and remove the plastic cove…
How to Change the Fuel Pump on Fiat 500
How to Change the Fuel Pump on Fiat 500
Fiat 500 (1957-1975 / Epoca) Replace the fuel pump on a Fiat 500. Here’s how to dismantle it. Lift the rear bonnet of the car, locate the fuel pump as shown in the video. Use a s…
How to Replace the Fuel Pump Filter on a KTM SX-F 350
How to Replace the Fuel Pump Filter on a KTM SX-F 350
Sx F 450 To replace the fuel pump filter on the KTM SX-F 350, remove the seat and disconnect the connector underneath, which is directly connected to the fuel…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos