Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch Master Cylinder on a KTM EXC 250

Model: Ktm Exc 250

Video tutorial

This guide will show you how to remove and replace the clutch master cylinder on the KTM EXC 250 enduro bike. First, place your bike on a stand and start unscrewing the fastening pins of the clutch lever to remove it. Next, remove the hydraulic circuit reservoir, then detach the master cylinder from the clutch lever as shown in the video.

At this point, replace the seals included in the kit and reinstall the new clutch cylinder, topping up with new brake fluid!


Updated on 30 June 2026 by ScegliAuto


Related tutorials

How to Replace the Clutch on a KTM EXC 250?
How to Replace the Clutch on a KTM EXC 250?
Exc 250 To replace the clutch on a KTM EXC 250, loosen the screws securing the plastic cover on top of the clutch casing. Once the cover is removed, you can …
How to Replace the Clutch on a KTM EXC 250?
How to Replace the Clutch on a KTM EXC 250?
Exc 250 The procedure for replacing the clutch on a KTM EXC 250 involves loosening the bolts that secure the clutch cover, which is located on the left side …
How to Replace the Clutch on a KTM EXC 250?
Exc 250 To replace the clutch on a KTM EXC 250, lay the bike on its left side to access the components on the right side. At the bottom, you will find the co…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos