Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Indicator Bulb on a KTM Duke 200?

Model: Ktm Duke 200
Part: Light bulb

Video tutorial

To replace the front indicator bulb on a KTM Duke 200, first loosen the screws located at the back of the handlebars to lower the front fairing of the bike. This will provide access to the screws securing the indicator light from the rear: by unscrewing these screws, the light can be removed, allowing you to disconnect the connector at the back.

Now, you can extract the bulb inside and insert the new one, refitting all previously removed components.


Updated on 23 July 2026 by ScegliAuto


Related tutorials

Replacing the Front Headlamp Bulb on a KTM Duke 200
Replacing the Front Headlamp Bulb on a KTM Duke 200
Duke 200 In today's video, you will learn how to remove and replace the front headlamp bulb on a KTM Duke 200. First, remove the side screws located near the …
How to Replace the Headlight Bulb on a KTM Duke 200
How to Replace the Headlight Bulb on a KTM Duke 200
Duke 200 In this guide, find the main instructions to remove and replace the dipped beam bulb of the front headlight on a KTM Duke 200. First, place the motor…
How to Replace the Front Headlight Bulb on the KTM Duke 200
How to Replace the Front Headlight Bulb on the KTM Duke 200
Duke 200 In this tutorial, see how to replace the front headlight bulb on the KTM Duke 200, a very simple and quick operation. First, ensure that the key is n…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos