Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Brake Pads on a KTM RC 125

Model: Ktm Rc 125
Part: Brake pads

Video tutorial

Follow this guide to remove and replace the front brake pads on the KTM RC 125 motorcycle, using the instructions provided below. First, place your motorcycle on a stand and begin to unscrew the bolts securing the front brake caliper to remove it from the disc.

Next, remove the retaining clip for the pads to take them out of the holder, as shown in the video. At this point, clean the caliper of any residual dirt and install the new high-quality brake pads; then, simply reassemble the braking system!


Updated on 24 July 2026 by ScegliAuto


Related tutorials

How to Replace the Brake and Clutch Lever on the KTM RC 125
How to Replace the Brake and Clutch Lever on the KTM RC 125
Rc 125 In today's tutorial video, you will learn how to remove and replace the rear brake lever or pedal on the KTM RC 125 motorcycle, as well as the 250 an…
How to Remove the Front Wheel of the KTM RC 125
How to Remove the Front Wheel of the KTM RC 125
Rc 125 Discover in this brief and simple guide the instructions on how to remove and replace the front wheel of the KTM RC 125 motorcycle. First, lift the m…
How to Replace the Battery in the KTM RC 125?
How to Replace the Battery in the KTM RC 125?
Rc 125 In this tutorial, see how to replace the battery in the KTM RC 125, a very simple and quick operation. Before proceeding, ensure the key is not inser…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos