Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Brake and Clutch Lever on the KTM RC 125

Model: Ktm Rc 125
Part:

Video tutorial

In today's tutorial video, you will learn how to remove and replace the rear brake lever or pedal on the KTM RC 125 motorcycle, as well as the 250 and 300 models. First, place your motorcycle on a stand and start by unscrewing the central fixing screw of the rear brake lever.

Next, unscrew the pin fixing screw, disconnecting the small spring as shown in the video. At this point, install the new rear brake lever, fitting the new original part; then reassemble everything by applying the reverse procedure of disassembly!


Updated on 24 June 2026 by ScegliAuto


Related tutorials

How to Replace the Front Brake Pads on a KTM RC 125
How to Replace the Front Brake Pads on a KTM RC 125
Rc 125 Follow this guide to remove and replace the front brake pads on the KTM RC 125 motorcycle, using the instructions provided below. First, place your m…
How to Replace the Air Filter on a KTM RC 125
How to Replace the Air Filter on a KTM RC 125
Rc 125 This guide will show you how to remove and replace the air filter of the engine on the KTM RC 125 motorcycle, as well as the Duke 125. First, place t…
How to Replace the Battery in the KTM RC 125?
How to Replace the Battery in the KTM RC 125?
Rc 125 In this tutorial, see how to replace the battery in the KTM RC 125, a very simple and quick operation. Before proceeding, ensure the key is not inser…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos