Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Clutch on the KTM EXC 500?

Model: Ktm Exc 500
Part: Clutch

Video tutorial

To replace the clutch on the KTM EXC 500, loosen the screws securing the cover on the right side of the bike. Once these screws are loosened, remove the cover to access the clutch underneath.

The clutch can then be removed by loosening the screws that secure its discs. At this point, you can install the new replacement clutch, securely fastening all the discs that comprise it. After installation, verify that everything functions correctly.


Updated on 27 July 2026 by ScegliAuto


Related tutorials

How do you replace the clutch of the KTM EXC 500?
How do you replace the clutch of the KTM EXC 500?
Exc 500 It will be possible to replace the clutch of the KTM EXC 500 by loosening the screws that secure the side panel located on the left side of the motor…
How to Replace the Side Stand on the KTM Exc 500
How to Replace the Side Stand on the KTM Exc 500
Exc 500 Today's instructions will show you how to remove and replace the side stand on the KTM Exc 500 enduro bike. First, disconnect and remove the existing…
How to Replace the Rear Sprocket on a KTM EXC 500
How to Replace the Rear Sprocket on a KTM EXC 500
Exc 500 Below are the main instructions for removing and replacing the rear sprocket on the KTM EXC 500 enduro bike. First, remove the rear wheel from your b…

How to Change the Engine Oil on a Benelli 150

To change the engine oil on a Benelli 150, ensure the bike is on a stable surface, using the centre stand to keep it upright. Before starting, it's helpful to run the engine for a few minutes to warm the oil and facilitate drainage. Turn off the engine and locate the drain plug situated under the engine. Using an appropriate spanner, loosen the plug and position a container underneath to collect the used oil. Allow it to drain completely, ensuring all the liquid is removed. Once emptied, carefully re-tighten the plug, avoiding overtightening. Using a funnel, slowly pour new oil into the tank, checking the level with the dipstick or inspection window. When the level is correct, start the engine for a couple of minutes to circulate the new oil, then turn it off and check the level again, topping up if necessary.

Watch the video!


by ScegliAuto

More videos