Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Ktm
    3. : Exc 200

How to Replace the Fork Seals and Oil on the KTM EXC 200

Model: Ktm Exc 200

Video tutorial

Follow these main instructions to disassemble and replace the fork seals and oil on the KTM EXC 200 enduro bike. First, place the bike on a stand and start by unscrewing the screws of the central handlebar plate; then unscrew the screws of the front fork to remove the entire leg, disconnecting it from the bottom, as shown in the video.

At this point, remove the fork seal and check the wear condition of the spring; once the seals are replaced, reassemble the fork by pouring in the appropriate oil.


Updated on 26 August 2026 by ScegliAuto


Related tutorials

How to Replace the Fork Oil on a KTM EXC-F 500
How to Replace the Fork Oil on a KTM EXC-F 500
Exc F 500 In this video tutorial, you will learn how to disassemble and replace the fork oil on the KTM EXC-F 500 enduro bike in simple and quick steps. First,…
How to Change the Oil and Seals of the Front Fork on the Aprilia SR 50
How to Change the Oil and Seals of the Front Fork on the Aprilia SR 50
Sr 50 Today, you will see the instructions to disassemble and replace the seals and oil of the front fork on the Aprilia SR 50 scooter. First, place the sc…
How to Replace the Front Tyre on the KTM EXC 300
How to Replace the Front Tyre on the KTM EXC 300
Exc 300 In this guide, you will learn the main instructions on how to remove and replace the front tyre on the KTM EXC 300 enduro bike. First, place the bike…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos