Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this guide, find instructions on how to remove and replace both the front and rear brake pads of the Kymco Xciting S 400i scooter. First, place your scooter on the centre stand and start unscrewing the bolts securing the brake caliper using a socket spanner with an extension; then remove the caliper from the disc by pressing the piston to retract it. At this point, clean the caliper of dirt, remove and replace the old brake pads with new ones (of excellent quality), and reassemble everything!

Updated on 3 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Brake Pads of the Kymco Xciting 400 S
Xciting S 400i Today, we will see how to remove and replace the front brake pads of the Kymco Xciting 400 S scooter, following the instructions below. First, place …
How to Replace the Exhaust on a Kymco Xciting S 400i
How to Replace the Exhaust on a Kymco Xciting S 400i
Xciting S 400i You can replace the exhaust on a Kymco Xciting S 400i by loosening the screws that secure the exhaust tip to its housing, located near the rear wheel…
How to Change the Engine Oil on Kymco Xciting S 400i?
How to Change the Engine Oil on Kymco Xciting S 400i?
Xciting S 400i To change the engine oil on the Kymco Xciting S 400i, first unscrew the oil drain plug located at the central lower part of the bike: this will allow…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos