Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on a Kymco 200i

Model: Kymco 200i
Part: Service warning light

Video tutorial

This video demonstrates the procedure to reset the service light on the Kymco 200i. The process is very simple and quick; just turn on the instrument panel without starting the engine. Then, press the ADJ button located on the left of the scooter for 2 seconds.

At this point, use the ADJ button to navigate to the maintenance section indicated by the remaining kilometres until the next service. Press the ADJ and Mode buttons simultaneously for 2 seconds, the oil light will turn off, and the displayed kilometres will reset to 0. In this model, the service light is represented by the oil light.


Updated on 13 September 2026 by ScegliAuto


Related tutorials

How to Replace the Handlebar on a Kymco KDT 200i
How to Replace the Handlebar on a Kymco KDT 200i
Kdt 200i In this video tutorial, you will see how to disassemble and replace the handlebar on the Kymco KDT 200i scooter, as well as on the Kymco Like 150i. F…
How to replace the battery of the Kymco Agility 200i?
How to replace the battery of the Kymco Agility 200i?
Agility 200i To replace the battery on the Kymco Agility 200i, loosen the screws securing the panel located in the centre of the bike, corresponding to the footre…
How do you reset the Service light on the Sym Symphony ST 200i?
How do you reset the Service light on the Sym Symphony ST 200i?
Symphony St 200i It will be possible to completely delete the Service light of the Sym Symphony ST 200i by turning on the instrument panel and repeatedly pressing the…

How to Replace the Belt and Rollers on the Piaggio Vespa GTS 300

This guide briefly outlines the steps to remove and replace the belt and rollers of the variator on the Piaggio Vespa GTS 300 scooter, following the instructions below. First, place your scooter on the centre stand and begin unscrewing the screws of the transmission cover to remove it; then unscrew the nut of the fan and that of the clutch bell, as shown in the video. At this point, remove the belt and then the variator, replacing the rollers found inside; install the new belt and reassemble the transmission!

Watch the video!


by ScegliAuto

More videos