Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Preparation: Make sure the motorcycle is turned off and the center stand is positioned correctly. Ensure that the motorcycle is stable and secure. Remove the exhaust muffler: Locate the exhaust muffler, which is the end part of the exhaust system. Disconnect any screws or bolts holding the muffler in place. Remove the muffler by gently pulling it outwards. Remove the exhaust header: Follow the exhaust pipe from the back of the motorcycle to the exhaust header. Disconnect the screws or bolts securing the header to the engine head. Remove the header carefully. Check the exhaust system: Inspect the exhaust system for any damage or wear. Clean the contact surfaces and remove any residue. Installing the new exhaust: Install the new header and muffler following the manufacturer's instructions. Ensure that all screws or bolts are tightly secured. Verify that the exhaust system is positioned correctly and does not interfere with other parts of the motorcycle. Final test: Start the motorcycle and check for leaks or abnormal noises from the exhaust system. Take a short test ride to ensure that everything is functioning properly.

Posted on 23 May 2024 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the exhaust pipe of the Kymco Agility 125?
How do you replace the exhaust pipe of the Kymco Agility 125?
Agility 125 In order to replace the exhaust pipe of the Kymco Agility 125, you need to loosen the screws of the supports that fix it to its housing so that it ca…
Removing Rear Wheel from Kymco Agility 125
Removing Rear Wheel from Kymco Agility 125
Agility 125 In this video tutorial, learn how to remove the rear wheel from a Kymco Agility 125. First, place the central stand and remove the exhaust silencer b…
How to Remove the Spark Plug from a Kymco Agility 125
How to Remove the Spark Plug from a Kymco Agility 125
Agility 125 Before you start, position your Kymco Agility 125 on the centre stand. Begin by removing the floor panel fairing by unscrewing the fixing screws. Nex…

How to replace the air filter in the Herald Classic 125?

In this tutorial, you will see how to replace the air filter in the Herald Classic 125, a very simple and quick operation. First, position yourself on the left side of the motorcycle, then grab the panel located under the seat, pull it towards you, and detach it from the frame. Next, unscrew the three fastening screws of the airbox cover, remove it, and take out the old filter from its housing. At this point, remove any dirt residue present, insert the replacement filter, and reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos