Do it yourself
Frequently asked questions about cars and motorcycles
  1. Motorcycles
  2. :
  3. Kymco
  4. : Xciting 250 R

Kymco Xciting 250 R - Videoguide

Kymco Xciting 250 R
How to reset the service of the Kymco Xciting 250

To reset the service indicator on your Kymco Xciting 250, you can follow these steps: Turn on the ignition of your Kymco Xciting 250 without starting the …read all…
Posted on 18 March 2024 by ScegliAuto
Kymco Xciting 250 R
How do you replace the clutch of the Kymco Xciting 250i?

In order to replace the clutch of the Kymco Xciting 250i, you need to loosen the screws that secure the transmission case, located on the left side of the …read all…
Posted on 26 February 2024 by ScegliAuto
Kymco Xciting 250 R
How do you replace the air filter on the Kymco Xciting 250?

To replace the air filter of the Kymco Xciting 250, you need to open the under-seat compartment so that you can access the internal part of the compartment. …read all…
Posted on 22 September 2023 by ScegliAuto
Kymco Xciting 250 R
How do you replace the engine oil of the Kymco Xciting 250 R?

The procedure for replacing the engine oil on the Kymco Xciting 250 R involves unscrewing the drain plug of the oil tank, which is located in the central lower …read all…
Posted on 2 August 2023 by ScegliAuto
Kymco Xciting 250 R
How do you replace the engine oil of the Kymco Xciting 250 R?

The oil change on the Kymco Xciting 250 R is done by unscrewing the drain plug of the oil tank, which is located in the central lower part of the motorcycle: …read all…
Posted on 29 July 2023 by ScegliAuto
Kymco Xciting 250 R
Oil change on Kymco Xciting 250 R

Warm up the engine (by starting it) for a few minutes, so that the oil is warm and fluid. First unscrew the upper filling hole near the oil filter, and only …read all…
Posted on 7 March 2024 by ScegliAuto
Air filter (1) Clutch (1) Engine oil (3) Instrument cluster (1)

How to replace the Ford Transit key battery

Below I will explain how to replace the remote control key battery on the car, take a small screwdriver and pry the rear part of the remote control, (where there is the ring), at which point unhook the back cover and yes will have access to the compartment containing the battery. Always with the help of the small screwdriver, proceed to make the va and lift the battery out of the housing. Then take the new battery (check the type) and place it on the housing, always making sure to position it with the positive pole facing upwards. Finally, close the back cover by re-hooking it to the key.

Watch the video!


by ScegliAuto

More videos