Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Camshaft Inspection Cover of the LML Star 200

Model: Lml Star 200

Video tutorial

These brief and simple steps will show you how to disassemble and remove the clutch cover of the LML Star 200. In this specific case, the camshaft inspection cover is removed with the engine disassembled, thus taken off the frame; it is possible to inspect with the engine installed by unscrewing the two screws of the cover located behind the cylinder head, as shown in the video.

If any anomalies are found, it will be necessary to disassemble and remove the cylinder head cover, checking the wear condition of the camshaft and valves; then correctly reassemble everything!


Posted on 8 February 2026 by ScegliAuto


Related tutorials

How do you disassemble the engine of the LML Star 200?
How do you disassemble the engine of the LML Star 200?
Star 200 In order to disassemble the engine of the LML Star 200, you will need to loosen the screws that fix it to its housing in the lower rear part of the f…
How do you disassemble the engine of the LML Star 200?
How do you disassemble the engine of the LML Star 200?
Star 200 The dismantling of the LML Star 200 engine can be carried out by loosening the screws that fix the engine block to its housing, in the central lower …
Guide to Removing the Engine Block of the LML Star 200
Guide to Removing the Engine Block of the LML Star 200
Star 200 In this brief and simple guide, you will find instructions to remove and open the engine block of the LML Star 200, as well as the Piaggio Vespa PX 2…

How to Replace Engine Oil in the Husqvarna TE 610?

In this tutorial, you will see how to replace the engine oil in the Husqvarna TE 610, a very simple and quick operation. Before proceeding, wait for the engine to cool completely to operate safely. Start by removing the lower protection panel, then locate the drain bolt on the right side and loosen it using a 14 mm socket spanner. Once all the oil has drained from the system, remove the filter, clean it of any dirt residue, and reassemble everything. Finally, insert the required amount of oil through the upper hole.

Watch the video!


by ScegliAuto

More videos