Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The disassembly operation of the engine of the Malaguti Phantom F12 125 can be carried out by completely removing the engine block from its housing, unscrewing the screws that fix it: once these have been removed, it will be possible to completely detach the cylinder, also removing the spark plug from the top. The piston contained inside can then be freed from its connecting rod by expanding the ring and removing the pin that fixes it. In this way, access to the crankshaft can also be obtained, by removing it and replacing any other components if necessary.

Posted on 24 October 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Dismantle the Engine of the Malaguti Phantom F12 125
How to Dismantle the Engine of the Malaguti Phantom F12 125
Phantom F12 125 You can dismantle the engine of the Malaguti Phantom F12 125 by loosening the screws that secure the block to its housing in the central lower part o…
How do you disassemble the engine of the Malaguti Phantom F12 125?
How do you disassemble the engine of the Malaguti Phantom F12 125?
Phantom F12 125 In order to disassemble the engine of the Malaguti Phantom F12 125, you need to loosen the screws that secure the cylinder to the top of the engine b…
How to remove the engine from a Malaguti Phantom F12 100?
How to remove the engine from a Malaguti Phantom F12 100?
Phantom F12 125 To remove the engine from a Malaguti Phantom F12 125, you need to completely detach the engine block from its housing by loosening the screws that se…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos