Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To change the engine oil of the Malaguti RST 125, loosen the screws that secure the fairing panels located at the lower central part of the bike: once the panels are removed, proceed to loosen the drain plug of the oil sump located at the lower central part of the vehicle. Once the plug is removed, allow the oil to drain into a container placed underneath and also remove the oil filter located in the same position. At this point, you can top up by pouring new oil through the breather located on the right.

Posted on 9 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Exhaust on the Malaguti RST 125
How to Replace the Exhaust on the Malaguti RST 125
Rst 125 To replace the exhaust on the Malaguti RST 125, loosen the screws securing the rear side fairings, located near the rear wheel on the left side. Unde…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos