Do it yourself
Frequently asked questions about cars and motorcycles

Front Headlamp Bulb Replacement

Model: Mazda Rx 8 MK 1 - Years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012
Part: Headlight bulb

Video tutorial

To replace the bulbs, it is necessary to completely remove the wheel to access the front light assembly. Unscrew the retaining screws of the cover, those under the wheel arch, and those under the bumper that secure the grille.

Remove the grille from the wheel arch, and you will finally have access to the light. Remove the protective cap with a flat screwdriver and using a T15 Torx key, unscrew the bulb holder, which should be gently pulled out from its seat after disconnecting the electrical connector.

Place the assembly on a support and extract the bulb by removing the clips. Install the new bulb.

Refit the bulb holder in its respective seat and reposition the light assembly in its housing, reconnecting the relevant connector. Screw in the retaining screws and reassemble everything.


Updated on 8 February 2026 by ScegliAuto


Related tutorials

Mazda Rx 8 (2003-2012 / MK 1) It will be possible to replace the fog light bulb of the Mazda RX-8 by lifting the car to remove the wheel on the side corresponding to the bulb that…
Mazda Rx 8 (2003-2012 / MK 1) In this video, we will discover the steps to remove the front headlight and replace the bulbs on the Mazda RX-8 in simple steps. First, open the bonn…
Mazda Rx 8 (2003-2012 / MK 1) To replace the rear light bulbs, you need to remove the entire light assembly. The screw is accessible on the side of the boot after removing the pla…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

Other guides you may be interested in

How to Reset the Tyre Pressure Light on the Hyundai i20

These brief instructions will show you how to reset the tyre pressure monitoring system (TPMS) light on the Hyundai i20. Before performing the reset, ensure that all four tyres are at the correct operating pressure. Then, get inside the cabin and turn on the ignition. Now, press and hold the TPMS reset button located on the left side of the driver's seat until the tyre pressure light resets on the instrument panel, as shown in the video. At this point, turn off the ignition and start the engine to complete the process!

Watch the video!


by ScegliAuto

More videos