Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace Engine Oil and the Oil Filter

Model: Mazda Mpv LW - Years 1999-2006
Part: Engine oil

Maintaining engine oil is essential to prevent seizing and wear. When performing this task, you usually also replace the oil filter; it is a very simple operation, within everyone's reach! Sometimes, the recommended oil specification for the engine is written on the oil cap; to check the level, use the dipstick. To work more effectively, raise the vehicle and to facilitate draining the oil, remove the dipstick and the drain plug. First, remove the oil cap located on the sump and let the oil drain for a few minutes into a suitable container, then replace the cap, ensuring it is tightened properly, replacing the washer (if present) on the bolt. Next, locate the filter (which can be immersion or metal) and using a strap wrench, unscrew it; once loosened, you can continue unscrewing it by hand, being careful of the oil that will spill. After that, fit the new one in its place (also replacing the washers) and tighten it without overdoing it. Lower the vehicle and add the necessary amount of oil (as found in the maintenance manual) but do not add it all (if it says 3 litres, add 2.5 litres). Start the engine and add the remaining oil.

Updated on 9 February 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Mazda Mpv (1999-2006 / LW) To easily replace the gearbox oil, lift the vehicle on suitable car stands. At the centre of the gearbox, on the side connecting to the engine, you w…
Mazda Mpv (1999-2006 / LW) Before proceeding with the alternator removal, disconnect the battery terminals. Lift the vehicle on a hydraulic lift or suitable axle stands, as the…
Mazda Mpv (1999-2006 / LW) The cabin air filter is located on the passenger side, behind the glove compartment door: open the door, press the sides to retract the end-stop pins…

Other guides you may be interested in

How to Replace the Remote Battery for the Volvo XC40?

In this tutorial, you will see how to replace the battery in the remote for the Volvo XC40, a very simple and quick operation. For this, you will need a replacement battery of type CR2032 and possibly a small flathead screwdriver. First, remove the front cover by pressing the button on the metal ring, then locate the second button, press it as well, and remove the opposite cover. Next, open the circular cap, take out the old battery, and insert the new one in the opposite direction. Finally, reassemble everything.

Watch the video!


by ScegliAuto

More videos