Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mazda
    3. :
  3. Cx 7
    4. : How to remove the Mazda CX-7 passenger compartment fan?

Mazda Cx 7 - Video tutorial

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Interior blower
Operation: How to remove the Mazda CX-7 passenger compartment fan?

Removing the passenger compartment heater fan in the Mazda CX-7 is a very simple operation, let's see how to proceed in this tutorial. Let's start by removing the cover underneath the glove box by disengaging it, then proceed by disconnecting the motor power cable and unscrewing the 3 fixing screws. At this point, we extract the entire block and proceed to replace the damaged element, be it the motor or the fan. To remove the latter, you must first unlock the upper metal clip that anchors it to the motor shaft. Finally, we reassemble everything following the reverse procedure.


Posted on 28 June 2022 by ScegliAuto



Removing the passenger compartment heater fan resistor motor.
Mazda Cx 7 (2006-2012 / MK 1) When the passenger compartment heating fan does not work because the resistor needs to be replaced, locate its position which, in this case, is beyon
Where is the fuse box located on a Mazda CX-7
Mazda Cx 7 (2006-2012 / MK 1) Let's see thanks to this short video tutorial where the two fuse boxes are located on a Mazda CX-7, model produced from 2006 until 2012. The first fu
How do you reset the adblue warning light in the Mazda Cx 7?
Mazda Cx 7 (2006-2012 / MK 1) When the adblue warning light comes on in the Mazda Cx 7 instrument panel, it should go out automatically when the latter is topped up. If this is no

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos