Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Power Steering Oil Top-Up Instructions

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Pump

If the steering becomes stiff, making it particularly heavy to turn, the first thing to check is the oil level in the power steering reservoir: this reservoir is located near the windscreen washer fluid tank; open the cap and check the oil level inside, and if necessary, top up to the maximum level using a specific hydraulic power steering oil. After topping up, verify the steering efficiency. It is also advisable to check for any leaks in the system.

Updated on 18 February 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you reset the AdBlue light on the Mazda CX-7?
How do you reset the AdBlue light on the Mazda CX-7?
Mazda Cx 7 (2006-2012 / MK 1) To reset the AdBlue light on the Mazda CX-7, you will need to perform a refill by inserting the necessary amount of additional liquid into the respec…
Guide to Replacing the Rear Light Bulbs on the Mazda CX-7
Guide to Replacing the Rear Light Bulbs on the Mazda CX-7
Mazda Cx 7 (2006-2012 / MK 1) In this brief and simple guide, learn how to remove and replace the rear light and its bulbs on the Mazda CX-7. First, open the rear hatch of the boo…
Replacing the Fuel Line on a Car
Replacing the Fuel Line on a Car
Mazda Cx 7 (2006-2012 / MK 1) The following guide provides instructions on how to replace the fuel line on a car. Disconnect the negative terminal of the battery to avoid sparks w…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos