Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Rear Bumper

Model: Mazda Cx 7 MK 1 - Years 2006-2012
Part: Rear bumper

Removing the rear bumper is quite simple, but you must first remove other elements such as the rear lights to access some of the bumper's fastening clips. Open the boot and remove the plastic cover shielding the rear light housing. Then, disconnect the lamp holders and unscrew the fastening nuts of the light to extract it from its housing. Next, proceed to remove the wheel arch cover inside the rear wings to unscrew the bumper fastening screws and extract the pressure clips located near the light housing. Once the bumper is removed, you can also detach the plastic supports located beneath the light housing.

Updated on 20 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Rear Bumper Trim
Removing the Rear Bumper Trim
Mazda Cx 7 (2006-2012 / MK 1) To remove the rear bumper, open the boot and proceed to remove the rear lights: remove the plastic cover located at the light housing and unscrew the…
Removal of Rear Impact Absorber Beam
Removal of Rear Impact Absorber Beam
Mazda Cx 7 (2006-2012 / MK 1) To remove the impact absorber beam located under the rear bumper, you must first remove the bumper itself. Start by removing the rear lights to acces…
Instructions for Removing the Front Bumper
Instructions for Removing the Front Bumper
Mazda Cx 7 (2006-2012 / MK 1) To remove the front bumper, start by opening the front bonnet and extracting the clips at the ends of the grille. Then move on to the clips that secu…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos