Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Slk
    4. : Interior fan motor inspection

Mercedes Slk - Video tutorial

Model: Mercedes Slk R170, MK 1 - Years 1997-2004
Part: Interior blower
Operation: Interior fan motor inspection

The fan for the recirculation of air in the passenger compartment is located on the top passenger, immediately under the glovebox: to reach it, first remove the side deflector at the beginning of the central tunnel and then the grille under the glovebox. At this point there are two white plastic plates that act as a stop to close the inspection compartment door of the fan speed regulator: slide the two plates inwards and open the flap to access the regulator. You will notice the power cables of the fan motor connected to the brush holder and the winding of the motor armature: a first step is to give a good blow to eliminate all the accumulated dust.


Posted on 13 August 2023 by ScegliAuto



The reason why the retractable roof of a Mercedes SLK is not functioning properly.
Mercedes Slk (2004-2011 / MK 2, R171) In this video, we see the main reason why the retractable roof of a Mercedes SLK may not work properly. It is very important to check the oil level o
How to remove the power steering pump from a petrol Mercedes SLK 350
Mercedes Slk (2004-2011 / MK 2, R171) In today's video we will see the main instructions to be able to disassemble and replace the power steering pump of a Mercedes SLK 350 petrol. First
Center console replacement
Mercedes Slk (1997-2004 / R170, MK 1) The following guide shows how to remove the central cabin tunnel to replace the center console. First of all, the knob must be removed, pushing hard

Other guides that may interest you

How to reset the oil service in the Fiat Toro?

In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle.

Watch the video!


by ScegliAuto

More videos