Do it yourself
| ||||
|
Mercedes Viano - Video tutorial
Model: Mercedes Viano
MK 1, W639
- Years 2003-2013 If you have to proceed with the replacement of the front shock absorbers you must immediately take into consideration the need to have the appropriate clamps to crush the springs; having said this, proceed by lifting the car on the bridge and removing the front wheel; disconnect the brake fluid pipe and the cables of the speed and brake wear sensors from the shock absorber; then unscrew the fixing pins of the shock absorber to the hub support and lower the car to access the engine compartment; at this point, in order to access the domes and therefore disassemble the shock absorber support, the plastic coating immediately under the windscreen must be removed by removing both the wiper blades and the relative drive mechanism; once the support has been disassembled, extract the shock absorber from its seat, apply the clamps to squeeze the spring just enough to remove the support from the stem and free the damper; insert the spring and the support complete with bellows on the new shock absorber and complete the assembly and then proceed backwards for installation on board the car.
Posted on 1 September 2023 by ScegliAuto
How to replace the rear shock absorber on a Mercedes Viano
Mercedes Viano (2003-2013 / MK 1, W639) Before we can start, we will have to go and lift our Mercedes Viano. So let's start by unscrewing and removing the bolts that secure the wheel to its
Replacement of front suspension springs
Mercedes Viano (2003-2013 / MK 1, W639) To be able to replace the springs of the front suspensions it is first of all necessary to have the appropriate clamps to squeeze the spring on the s
How to replace the front wiper blades on a Mercedes Viano
Mercedes Viano (2003-2013 / MK 1, W639) How to replace the front wiper blades on a Mercedes Viano? Take the front brush (with your hands), pull the movable brush (gently without breaking it Other guides that may interest you
|
How to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.073
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |