Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Clk
    4. : Ignition coil replacement

Mercedes Clk - Video tutorial

Model: Mercedes Clk W208 - Years 1997-2003
Part: Coil
Operation: Ignition coil replacement

If it happens that the engine has difficulty starting or, once started, it runs irregularly and even the engine warning light comes on, the defect is certainly to be found in the non-ignition of some cylinders: a check of the fault memory in the engine management control unit with the diagnostic tool will reveal the fault code and the cylinder lacking the ignition; in this case there is a problem with the first cylinder: then remove the plastic cover on top of the engine, disconnect the coil power socket and the cables that feed the spark plugs from the coil, unscrew the fixing screw in the center of the reel and proceed backwards to install the new one.


Posted on 8 September 2023 by ScegliAuto



How do you reset the automatic transmission of the Mercedes CLK?
Mercedes Clk (2002-2010 / W209) In order to reset the automatic transmission of the Mercedes CLK, you need to insert the ignition key into the ignition switch, so that the instrumen
Xenon headlight control unit connection
Mercedes Clk (2002-2010 / W209) The damage to the ignition unit of the xenon lamps of the Mercedes headlights is a fairly recurring defect: it is in any case possible to buy it also
To reset the ESP warning light on a Mercedes.
Mercedes Clk (1997-2003 / W208) Resetting the ESP light on a Mercedes Clk class 208 is a very simple operation that can be done independently, as some models do not require a reset

Other guides that may interest you

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos