Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Mercedes
    3. :
  3. Classe A
    4. : Disassembly of the steering wheel of the Mercedes A-Class

Mercedes Classe A - Video tutorial

Model: Mercedes Classe A W168 - Years 1997-2004
Part: Steering wheel
Operation: Disassembly of the steering wheel of the Mercedes A-Class

Let's see the instructions that will allow us to disassemble and replace the steering wheel of the Mercedes Classe A, following these simple steps. First of all, we get into the cabin and start by disassembling and removing the steering wheel airbag; to do this, we push on the rear holes with something thin and pointed, then disconnect its electrical connector, as shown in the video. At this point, we use a socket wrench to unscrew the central screw of the steering wheel; then we remove it and replace it with the new one, as well as with the original one, finally reassembling the steering wheel airbag!


Posted on 20 October 2023 by ScegliAuto

    Frequently Asked Questions

    • Classe A 1997-2004 - How much does the Mercedes A-Class light and wiper control cost? Read Answer
    • Classe A 2012-2018 - Where is the oil tank for the power steering of a Mercedes A-Class 160 elegance located? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos