|
Do it yourself
| |||
| ||||
Video tutorial
I will explain how to replace the lock cylinder of your door. Gather a set of plastic trim tools, Torx keys, and hex keys. Start by opening your door. Using the kit mentioned, gently pry the panel towards you. You will hear clips releasing on each side of the panel; carefully remove each trim piece. Next, remove all screws with Torx keys, then extract the window from the window regulator for easier access. Once done, disconnect all connectors present, then remove the remaining screws. Now, remove all seals and finally the door panel. Disconnect the tension cable for the door opening to access the handle and remove it easily. After these steps, remove the lock cylinder using the appropriate hex key; take everything out and replace it with the new part. Reassemble everything in reverse order, and your job will be complete. Now your car will lock perfectly.
Updated on 25 February 2026 by ScegliAuto
Related tutorials
Mini
(2001-2007 /
R53, R50, R52)
A complete service involves changing the engine oil and all filters, including the spark plugs; start by replacing the engine air filter, then move o…
Mini
(2007-2014 /
R57, R56, R55)
Replacing the cabin air filter on the Mini Cooper is a very simple task that can be done independently. The first step to replace the cabin filter wi…
Mini
(2007-2014 /
R57, R56, R55)
In this short video, see how to easily replace the cabin air filter on the Mini Cooper R56. To do this, position yourself on the passenger side and g…
Other guides you may be interested in
|
How to Extract the Spare Wheel from a Mercedes Vito
The spare wheel of a Mercedes Vito is located underneath the vehicle, just below the rear boot. This video demonstrates how to extract the wheel from its compartment. First, open the boot and locate the tools provided with the vehicle to release the wheel; these can be found in a compartment on the right side of the boot. As shown in the video, use the supplied screwdriver to remove the cover cap from the hole where you will insert the socket spanner; this hole is located beneath the rubber seal above the rear bumper. Insert the spanner and attach the extension to allow you to turn it and lower the wheel from under the floor. Finally, detach the pin that allowed the wheel to lower and proceed to extract it from under the vehicle. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.097
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
