|
Do it yourself
| |||
| ||||
|
Model: Moto Guzzi V7 Iii
This video shows how to remove and replace the brake and clutch levers on a Moto Guzzi V7 III. First, remove the front brake lever by unscrewing the fixing pin using a flat screwdriver and a spanner to hold the lower nut, as shown in the video. Once the lever is removed, replace it with the new one, securing the pin again. Next, move to the clutch lever, where you will perform the same procedure; however, disconnect the clutch cable in this case. Finally, make the necessary adjustments to the levers!
Updated on 5 May 2026 by ScegliAuto
Video tutorial
Related tutorials
V7 Iii
As is advisable whenever performing maintenance on a motorcycle, secure your Moto Guzzi V7 III on a stable and safe stand. This way, you ensure the o…
V7 Iii
To adjust the clutch lever on the Moto Guzzi V7 III, tighten the nut located at the left handlebar lever: tightening this nut will reduce the lever t…
V7 Iii
In this guide, you will learn how to remove and replace the rear brake pads on the Moto Guzzi V7 III in simple and quick steps. First, place your mot…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
