Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Engine Oil of the Moto Guzzi V7 Special?

Model: Moto Guzzi V7 Special
Part: Engine oil

Video tutorial

To change the engine oil of the Moto Guzzi V7 Special, unscrew the oil drain plug located at the front bottom of the bike. Once the plug is removed, allow all the used oil to drain into a suitably positioned container.

After the oil has drained, remove the oil filter from the central bottom of the bike and replace it with a new one. At this point, top up the oil through the breather located on the left side of the bike.


Updated on 30 June 2026 by ScegliAuto


Related tutorials

Replace the Engine Oil and Oil Filter of the Moto Guzzi V7 Special
Replace the Engine Oil and Oil Filter of the Moto Guzzi V7 Special
V7 Special Follow the main instructions below to carry out the routine maintenance service by replacing the engine oil and oil filter of the Moto Guzzi V7 Speci…
How to replace the engine oil and oil filter of the Moto Guzzi V7 Special 850
How to replace the engine oil and oil filter of the Moto Guzzi V7 Special 850
V7 Special In this short guide, we will see how to perform the routine maintenance service by replacing the engine oil and oil filter of the Moto Guzzi V7 Speci…
How to Replace the Exhaust on a Moto Guzzi V7 Special
How to Replace the Exhaust on a Moto Guzzi V7 Special
V7 Special To replace the exhaust on a Moto Guzzi V7 Special, loosen the screws that secure the exhaust terminal to its housing, located near the rear wheel on …

How to Replace the O-ring on the Clutch Rod of the LML Star?

To replace the O-ring on the clutch rod of the LML Star, lift the bike to loosen the side panel located near the rear wheel. Next, unscrew all the screws securing the rear wheel and the corresponding transmission cover: by removing the clutch, you will be able to locate the rod positioned behind it. This rod can now be removed from its housing by unscrewing the fastening screws; after the old rod has been removed, slide out the O-ring, replace it with a new one, and reassemble all previously removed components.

Watch the video!


by ScegliAuto

More videos