Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Lambda Sensor on the Opel Corsa

Model: Vauxhall Corsa - Years: 2014, 2015, 2016, 2017, 2018, 2019
Part: Oxygen sensor

See other generations:
Video tutorial

In this brief guide, you will learn how to remove and replace the lambda sensor or oxygen sensor on the Opel Corsa. First, lift the vehicle and locate the lambda sensor, positioned after the catalytic converter; disconnect its electrical connector and unscrew the sensor with a spanner to remove it, as shown in the video.

Now replace and install the new oxygen sensor, screwing it in by hand before tightening with a spanner; reconnect the electrical connector and reset any engine fault light using diagnostic software.


Posted on 20 November 2026 by ScegliAuto


Related tutorials

Vauxhall Corsa (2006-2014 / Corsa D) Removing the Lambda sensor? Let's see how on the Opel Corsa. Pull the engine compartment release lever located at the bottom left of the dashboard an…
Vauxhall Corsa (2000-2006 / Corsa C) In this video, see how to remove and replace the lambda sensor on an Opel Corsa. Open the bonnet, then disconnect the battery terminals and prepare t…
Vauxhall Corsa (2000-2006 / Corsa C) In today's video, we will see instructions on how to remove and replace the lambda sensor or oxygen sensor on an Opel Corsa. First, lift the vehicle …
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

Where is the battery located on the Aprilia Scarabeo 250ie scooter?

This video shows where the battery is located on the Aprilia Scarabeo 250ie scooter and how to proceed if you need to replace it. As shown, it is located beneath the seat. To access and replace it, first open the seat, then remove the plastic cover by unscrewing the relevant screws with a cross-head screwdriver. Next, disconnect both terminals, starting with the negative, remove the battery from its housing, and install the new replacement following the reverse procedure.

Watch the video!


by ScegliAuto

More videos