Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing the Rear Bumper on an Opel Astra Sw (J)

Model: Vauxhall Astra Astra J - Years: 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016
Part: Rear bumper

See other generations:
Video tutorial

In this video, we will see how to remove the rear bumper on an Opel Astra J, in station wagon version. First, open the boot lid and start by unscrewing the screws securing the rear lights, which are located on the sides, using a Torx T20 spanner; then disconnect the electrical connector of the bulbs and pull the unit outside, as shown in the video.

At this point, unscrew the screws found on both sides of the wheel arches; all that remains is to remove the plastic clips located under the bumper to take it off, following the video to the end!


Updated on 18 April 2026 by ScegliAuto


Related tutorials

Removing the Rear Bumper from an Opel Astra
Removing the Rear Bumper from an Opel Astra
Vauxhall Astra (2004-2010 / Astra H) The following instructions will guide you on how to remove and replace the rear bumper of an Opel Astra in simple steps. First, open the rear tailgat…
Removing the Rear Bumper of the Opel Astra
Removing the Rear Bumper of the Opel Astra
Vauxhall Astra (2004-2010 / Astra H) This guide briefly outlines the steps to remove and replace the rear bumper of the Opel Astra. First, open the boot lid and begin unscrewing all the …
Removing the Front Bumper on an Astra J
Removing the Front Bumper on an Astra J
Vauxhall Astra (2009-2016 / Astra J) Let's see how to remove the front bumper on an Opel Astra. Remove the bumper to replace it with a new one. Lift the car on a jack, then unscrew the s…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos