Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing Rear Bumper on Opel Astra H

Model: Vauxhall Astra Astra H - Years 2004-2010
Part: Rear bumper

In this video tutorial, you will learn how to remove the rear bumper on an Opel Astra H in simple steps. First, open the boot and then open the side cover to remove the fixing screws of the rear lights; then disconnect the electrical connector of the bulbs and take out the rear lights. Next, remove the number plate lights by taking off the lenses; then unscrew the screws located on both sides of the wings and start detaching the rear bumper from the sides before removing it, as shown in the video!

Updated on 4 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Removing the Rear Bumper from an Opel Astra
Removing the Rear Bumper from an Opel Astra
Vauxhall Astra (2004-2010 / Astra H) The following instructions will guide you on how to remove and replace the rear bumper of an Opel Astra in simple steps. First, open the rear tailgat…
Removing Rear Bumper Opel Astra J
Removing Rear Bumper Opel Astra J
Vauxhall Astra (2009-2016 / Astra J) In this guide, you will see how to remove the rear bumper from an Opel Astra J Station Wagon by following these instructions. First, open the boot an…
Removing the Rear Bumper of the Opel Astra
Removing the Rear Bumper of the Opel Astra
Vauxhall Astra (2004-2010 / Astra H) This guide briefly outlines the steps to remove and replace the rear bumper of the Opel Astra. First, open the boot lid and begin unscrewing all the …

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos