Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacement of front brake pads

Model: Vauxhall Vectra Vectra C, MK 3 - Years: 2002, 2003, 2004, 2005, 2006, 2007, 2008
Part: Brake pads

See other generations:
Video tutorial

Remove the plastic covers from the wheel bolts and unscrew the nuts. Lift the vehicle and remove the brake caliper by taking off the two spring clips with pliers.

Remove the two plastic covers and use a 7mm hex key to free the cylinder from both sides. Clean the edge of the disc and retract the cylinder.

Replace the pads, taking care not to damage the cylinder's position. Release the fluid into the piston and reposition the cylinder.

Realign the piston by pushing it inwards and check the pads' adherence to the disc. Refit the springs and check the brake fluid level, topping it up if necessary.


Updated on 2 February 2026 by ScegliAuto


Related tutorials

Replacement of Front Brake Pads
Vauxhall Vectra (1995-2002 / Vectra B, MK 2) Lift the vehicle on a ramp or suitable axle stands; then remove the front wheel, take off the protective caps from the brake caliper mounting pins, a…
Replacement of Rear Brake Pads
Replacement of Rear Brake Pads
Vauxhall Vectra (1995-2002 / Vectra B, MK 2) Once the vehicle is on suitable axle stands, remove the rear wheel and proceed to remove the retaining pins of the brake caliper (only remove the low…
Replacement of Front Brake Pads
Replacement of Front Brake Pads
Vauxhall Vectra (2002-2008 / Vectra C, MK 3) Remove the plastic covers from the wheel bolts and unscrew the nuts. Lift the vehicle and detach the brake caliper by removing the two spring clips w…

Other guides you may be interested in

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos