Do it yourself
Frequently asked questions about cars and motorcycles
From the riding position, remove the two side screws located underneath the handlebar using a T25 Torx spanner. Also, remove the other two lower side screws, as shown in the video. At this point, detach the front fairing from its housing. Disconnect the connector by pressing on it and not pulling the wires, otherwise, you may damage them. Unscrew the bulb from the bottom and remove it. Insert the new bulb and screw it in. Then reassemble everything in reverse order: connect the connector, mount the fairing with the headlamp, and screw in the fixing screws.

Updated on 23 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Speedfight Today, you will learn how to remove the rear light on a Peugeot Speedfight scooter by following these simple instructions. First, open the seat of yo…
Speedfight In this guide, see how to remove and replace the front wheel or tyre of the Peugeot Speedfight scooter by following these simple steps. First, place …
Speedfight To replace the shock absorbers of the Peugeot Speedfight, loosen the bolts that secure them at the top and bottom, both for the front and rear wheels…

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos