Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Centre Console of the Peugeot 508

Model: Peugeot 508 MK 2 - Years: 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025, 2026
Part: Checks and maintenance

See other generations:
Video tutorial

In this video, learn how to remove the centre console of the Peugeot 508, located between the two front seats: use a plastic spatula to pry from the sides to remove the trim, taking care not to damage the clips on the sides. Once it is free from its housing, disconnect the electrical connectors.

The YouTuber polished the trim with fine abrasive paste to remove superficial scratches and give a shiny finish to the entire trim. Clean the switch panel thoroughly, checking all contacts, and then vacuum inside the compartment to remove dust and debris.

Now refit the polished trim by reconnecting the electrical connectors, replace the switch panel, and you're done.


Updated on 29 October 2026 by ScegliAuto


Related tutorials

How to Disable the "Eco" Mode on a Peugeot 508?
How to Disable the "Eco" Mode on a Peugeot 508?
Peugeot 508 (2018-2026 / MK 2) Good morning, today’s goal is to permanently disable the "Eco" mode on your Peugeot 508. Start by turning on the vehicle using the ignition button lo…
How do you set the clock on the Peugeot 508?
How do you set the clock on the Peugeot 508?
Peugeot 508 (2010-2018 / MK 1) In order to set the clock of the Peugeot 508, you need to turn on the instrument panel by inserting the ignition key into the corresponding slot: onc…
Where is the EOBD port located on a Peugeot 508?
Where is the EOBD port located on a Peugeot 508?
Peugeot 508 (2010-2018 / MK 1) Let's see in this video where the EOBD port is located on a Peugeot 508: EOBD stands for European On Board Diagnostic, and this diagnostic port allow…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos