Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Peugeot
    3. :
  3. 3008
    4. : Replacing the headlight bulb in the Peugeot 3008

Peugeot 3008 - Video tutorial

Model: Peugeot 3008 MK 1, T84 - Years 2009-2016
Part: Headlight
Operation: Replacing the headlight bulb in the Peugeot 3008

To replace the headlight bulb in the Peugeot 3008, we must first open the front hood of the engine compartment of the car itself. We complete this operation by pulling the small lever located at the bottom left of the driver's side, at the bottom near the door hinge (see images for precise location). Once this is done, let's check the rear part of the headlight, of which we want to replace the bulb, from the inside of the engine compartment. We find the plastic cover, for protection from humidity and water, which we can remove by pulling it by the special tab. Now we proceed to disconnect the plug of the power supply by tightening it by the 2 clips and pulling. We unlock the bulb to be replaced from its joint and extract it. We can now assemble the new bulb and reassemble everything by repeating all the procedures seen following, of course, the reverse procedure.


Posted on 6 November 2023 by ScegliAuto

Other guides that may interest you

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos