Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Reset the Service Light on Piaggio Vespa Primavera 125?

Model: Piaggio Vespa 125 Primavera
Part: Service warning light

Video tutorial

You can eliminate the Service light displayed on the instrument panel of the Piaggio Vespa Primavera 125 by turning on the ignition, inserting the key into the corresponding ignition switch; at this point, press and hold the lever to access the menu located on the left side of the handlebars.

Keep this lever pressed for about ten seconds until the Service light starts flashing and then turns off completely; once the reset of the light has occurred, you can release the button and remove the key.


Posted on 10 April 2026 by ScegliAuto


Related tutorials

How to reset the Service light on the Piaggio Vespa 125 Primavera?
How to reset the Service light on the Piaggio Vespa 125 Primavera?
Vespa 125 Primavera From the instrument panel of the Piaggio Vespa 125 Primavera, you can clear the Service light by inserting the ignition key into the corresponding lo…
How to Replace the Spark Plug on a Piaggio Vespa Primavera 125?
How to Replace the Spark Plug on a Piaggio Vespa Primavera 125?
Vespa 125 Primavera Good morning, today’s guide aims to replace the spark plug on your Piaggio Vespa Primavera 125. Start by removing the side panels of the scooter. Nex…
How to reset the service on the Piaggio Vespa Primavera 125 scooter?
How to reset the service on the Piaggio Vespa Primavera 125 scooter?
Vespa 125 Primavera In this tutorial, you can see how to reset the 1000 km service on the Piaggio Vespa Primavera 125 scooter, an extremely simple and quick operation to…

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos