Do it yourself
Frequently asked questions about cars and motorcycles
The front suspension locking system of the Piaggio MP3 is designed to keep the vehicle upright without having to put your feet on the ground when stationary. It is activated via a button on the right side of the handlebar or, on some models, automatically under certain conditions. The operation is based on an electro-hydraulic system that locks the joint of the parallel front wheel scheme: when activated, the lock prevents the two front wheels from oscillating independently, keeping the vehicle balanced. To activate it: press the button with the vehicle moving at low speed (below 12-15 mph) or when stationary, with the engine running and the rear or front brake applied. The system activates only if conditions allow (low speed, brake applied). Once locked, the vehicle remains upright on its own: you can take your hands off the handlebar and place your feet on the footrests. To unlock: press the button again, or accelerate (the lock automatically deactivates when you set off). On some models, the lock disengages automatically when exceeding a certain speed or in an emergency. Note: the lock is not a stand and should not be used on steep inclines; it is only for short stops. If the system does not activate, there may be a problem with sensors, low hydraulic oil pressure, or a flat battery.

Posted on 26 September 2026 by ScegliAuto

Video tutorial

Related tutorials

Mp3 300 As the time for a service on the Piaggio MP3 approaches, a spanner icon appears on the speedometer display to remind you. After completing all the ma…
Mp3 300 To replace the rear wheel of your Piaggio MP3, follow these steps. First, make sure to lift the scooter safely using a stand or another stable surfac…
Mp3 300 Today's instructions will allow us to change the time on the display of the instrument panel of the Piaggio MP3 300 HPE scooter. First, we put the sc…

How to Reset the Service Light on a KTM RC 200

In this mini guide for your KTM RC 200, you will learn how to correctly perform a manual reset of the service light that appears on your bike's dashboard at each start. First, insert the key and turn on the ignition. Then, locate the "Mode" and "Set" buttons on the left side of the dashboard and press "Mode" multiple times until you see the total kilometres travelled. At this point, press and hold the "Set" button and release it as soon as the reset is successfully completed. Finally, turn off the ignition or start the engine to get moving.

Watch the video!


by ScegliAuto

More videos