Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Piaggio
    3. :
  3. Mp3 500
    4. : How do you replace the Piaggio MP3 variator?

Model: Piaggio Mp3 500
Part:
How do you replace the Piaggio MP3 variator?

In order to replace the Piaggio MP3 variator, loosen the bolts that secure the crankcase cover at the rear wheel, immediately under the air filter box. Once the cover has been removed, it will be possible to access the components inside it: in order to remove the variator, it is necessary to unscrew the central nut that fixes it to its pin, also freeing it from the belt itself. At this point it will be possible to insert the new spare part and reposition the belt around it, covering everything with the crankcase cover.


Posted on 23 June 2022 by ScegliAuto



How do you replace the Piaggio Mp3 500 transmission?
Mp3 500 The operation of replacing the transmission on the Piaggio MP3 500 is carried out by loosening the bolts which fix the carter placed on the left side
How to reset the maintenance light on the Piaggio MP3 500
Mp3 500 For this brief guide we will see how to reset the maintenance light for the Piaggio MP3 500. It should be noted that the following procedure is also
How to replace the coolant of the Piaggio MP3 500.
Mp3 500 Today's guide will show us the steps that will allow us to replace the coolant of the Piaggio MP3 500 scooter. First, we put the scooter on the cente

How to change the Royal Enfield Himalayan engine oil and filter

The guide shows you how to change the Royal Enfield Himalayan engine oil and oil filter. The first operation to perform is to secure the vehicle and turn it on to make the oil fluid. At this point, after having placed protection against splashes under the bleed valve and having prepared a container for the disposal of used oil, with a 22 mm wrench, open the valve. Using an 8 mm wrench, remove the fixing bolts of the inspection hatch of the mesh filter and extract the latter. Refit the clean filter and close the door; install the gasket on the purge valve and tighten it in place. On the opposite side of the vehicle, unscrew the three 8 mm bolts and drain the oil from the filter. Remove the old cartridge and clean the housing. Pour some oil into the new cartridge to facilitate the circulation of the oil. Put everything back in place. Fill the tank to the correct level and run the engine for a few minutes. Check the level again and top up if necessary.

Watch the video!


by ScegliAuto

More videos