Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Take the speedometer cable and pull out the inner cable to insert it into the designated hole in the steering column. Move down and remove the rubber protection on the wheel, then use a 14 mm spanner to undo the nut underneath it. Also remove the side screw, insert the speedometer gear, and refit the screw. Arrange the cable as shown in the video, then screw in the speedometer and position it correctly in its housing. Finally, insert the speedometer cable into the lower hole and then into the gear.

Updated on 4 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Clutch Cable on the Piaggio Vespa 50 Special?
How to Replace the Clutch Cable on the Piaggio Vespa 50 Special?
Vespa 50 Special To replace the clutch cable on the Piaggio Vespa 50 Special, loosen the bolts securing it near the rear wheel on the right side of the scooter. Once …
Fitting the Spare Wheel on a Piaggio Vespa 50 Special
Fitting the Spare Wheel on a Piaggio Vespa 50 Special
Vespa 50 Special A useful accessory to fit on a Piaggio Vespa 50 Special is the spare wheel. First, obtain a rim, which you can find used and restore yourself, along …
How to remove the wheel and tyre from the Piaggio Vespa 50 Special
How to remove the wheel and tyre from the Piaggio Vespa 50 Special
Vespa 50 Special Today's video will show you how to remove and replace the wheel or tyre of the Piaggio Vespa 50 Special, as well as the Vespa PK 50 and PX 125. First…

How to Change the Engine Oil on a Triumph Tiger 900?

To change the engine oil on the Triumph Tiger 900, follow these steps. First, ensure the engine is warm but not too hot. Lift the motorcycle on a centre or side stand to make it stable. Locate the oil drain plug on the engine casing, usually positioned on the lower side of the engine. Place an oil collection container under the drain plug and unscrew the plug to allow the used oil to drain out. Once the oil has completely drained, remove and replace the oil filter. Be sure to lubricate the sealing ring of the new filter before installing it. Reinstall the oil drain plug and ensure it is tightly secured. Next, locate the oil filler cap on the engine and remove it. Fill the engine with new engine oil, using the oil recommended in the owner's manual. Check the oil level using the dipstick and add oil if necessary to reach the correct level. Finally, screw the oil filler cap back on, start the engine, and check for any oil leaks. Recheck the oil level and add oil if necessary. Once the procedure is complete, dispose of the used oil properly at an authorised recycling centre.

Watch the video!


by ScegliAuto

More videos