Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Air Filter on the Piaggio Vespa PX 125 - LML Star 125

Model: Piaggio Vespa Px 125
Part: Air filter

Video tutorial

In today's tutorial, you will learn how to remove and replace the air filter of the carburettor on the Piaggio Vespa PX 125, as well as the LML Star 125 and Star 150. First, remove the right side panel of the engine and start by taking off the carburettor box cover; then, undo the screws of the intake duct, removing the sleeve as shown in the video.

At this point, replace the old filter with a new one of the correct type; insert it properly onto the carburettor and tighten the clamp to secure it, following the tutorial until the end!


Updated on 9 June 2026 by ScegliAuto


Related tutorials

How to Remove the Engine from a Piaggio Vespa PX 125 - Lml Star 125
How to Remove the Engine from a Piaggio Vespa PX 125 - Lml Star 125
Vespa Px 125 .. the bodywork of the Piaggio Vespa PX 125 and the LML Star 125. First, place the central stand on your scooter and start by removing the side storage.. …
How to Change the Rear Wheel of the Piaggio Vespa PX 125 - Lml Star 125
How to Change the Rear Wheel of the Piaggio Vespa PX 125 - Lml Star 125
Vespa Px 125 .. wheel of the Piaggio Vespa PX 125, as well as the Lml Star 125 and 150. First, place the central stand and start by removing the left side storage box;.. …
How to Replace the Rear Suspension on a Piaggio Vespa PX 125 - Lml Star 125
How to Replace the Rear Suspension on a Piaggio Vespa PX 125 - Lml Star 125
Vespa Px 125 .. on a Piaggio Vespa PX 125, as well as on an Lml Star 125. First, place the central stand and begin to lift the rear wheel off the ground; then use.. …

How to change the transmission oil on the Honda PCX 150 scooter?

In this tutorial, you will see how to change the transmission oil on the Honda PCX 150 scooter, a very simple and quick operation. First, ensure the engine is completely cold, then locate the three bolts at the end of the casing and position a container underneath them. Next, remove the two inner bolts using a 12 mm socket, clean them of any dirt, and allow all the oil in the system to drain out. At this point, tighten the lower bolt and, using a pump or syringe, add new oil through the upper hole.

Watch the video!


by ScegliAuto

More videos