Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change the Coolant in the Piaggio Vespa GTS 300 HPE

Model: Piaggio Vespa Gts 300
Part: Antifreeze coolant

Video tutorial

In this guide, you will learn how to bleed and top up the coolant in the Piaggio Vespa GTS 300 HPE, following the instructions below. First, place your scooter on the centre stand and begin by removing the plastic panel located under the handlebars; then unscrew the radiator cap, as shown in the video.

Now disconnect the bleed hose located on the water pump, allowing the fluid to drain into a container for about ten minutes; then top up by pouring the appropriate antifreeze into the radiator!


Updated on 12 June 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil and Oil Filter of the Piaggio Vespa GTS 300 HPE
How to Change the Engine Oil and Oil Filter of the Piaggio Vespa GTS 300 HPE
Vespa Gts 300 Today, we will discover the steps to carry out the routine maintenance service by replacing the engine oil and oil filter of the Piaggio Vespa GTS 30…
How to Remove the Front Headlight on a Piaggio Vespa GTS 300 - Super - HPE
How to Remove the Front Headlight on a Piaggio Vespa GTS 300 - Super - HPE
Vespa Gts 300 In this brief and simple guide, you will find instructions to remove and replace the front headlight of the Piaggio Vespa GTS 300 scooter, as well as…
How to Top Up the Coolant in the Piaggio Vespa GTS 300
How to Top Up the Coolant in the Piaggio Vespa GTS 300
Vespa Gts 300 This guide shows how to check the coolant level in the Piaggio Vespa GTS 300 by following these simple and quick steps. First, place the scooter on i…

How to Replace the Exhaust on the Suzuki GSX-R 600

To replace the exhaust on the Suzuki GSX-R 600, loosen the screws that secure the exhaust end can to its housing, located near the rear wheel on the right side of the bike. At this point, you can proceed by widening the connecting ring between the exhaust and the collector. Next, completely detach the old exhaust to position the new one: connect it to the collector by reinserting the ring and securing it to the bike's side supports.

Watch the video!


by ScegliAuto

More videos