Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Polestar
    3. : Polestar 4

Replacement of the battery of a Polestar 4 key

Model: Polestar Polestar 4 MK 1 - Years 2023-2026
Part: Key

Through this very short video tutorial today, we can see how to reach and replace the battery (CR2450) of a Polestar 4 key, model produced from 2023 onwards. Therefore, the operation is quite simple and we can carry it out independently and in a few seconds. First, using a flathead screwdriver, we remove the cover of the remote control as shown in the video, once this is done we will immediately have the old battery to replace in front of us, so we can proceed calmly to remove the old battery and then replace it with a new one, closing everything afterwards.

Posted on 28 October 2025 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Remote Battery in the Polestar 2
How to Replace the Remote Battery in the Polestar 2
Polestar Polestar 2 (2022-2026 / MK 1) This guide shows how to replace the battery in the Polestar 2 remote. The required battery for replacement is the CR2032 model. First, press the smal…
How to reset the TCAM of the Polestar 2
How to reset the TCAM of the Polestar 2
Polestar Polestar 2 (2022-2026 / MK 1) Below we will see the steps that will allow us to reset the TCAM of the Polestar 2. First of all, we open the front hood of the vehicle and start dis…
How to charge the battery of the Polestar 2
How to charge the battery of the Polestar 2
Polestar Polestar 2 (2022-2026 / MK 1) The battery of the Polestar 2 is located inside the front hood under the left side cover of the hood. To access the battery, we need to open the fron…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos