Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. RAM
    3. :
  3. Ram 1500
    4. : Rear bumper

RAM 1500 - Rear bumper

RAM 1500 (2019-2024 / MK 5, DT)
How do you remove the rear bumper of the Ram 1500?
In order to replace the rear bumper of the Ram 1500 you have to go to the lower part of the car, disconnecting all the connectors connected to the device. Once …read all…
Posted on 30 September 2022 by ScegliAuto
RAM 1500 (2009-2019 / DS, DJ, MK 4)
How do you remove the rear bumper of the Ram 1500?
To be able to replace the rear bumper of the Ram 1500 you have to disconnect all the connectors connected internally, accessing the two rear wheel arches. Once …read all…
Posted on 13 September 2022 by ScegliAuto
Airbags (5) Alternator (1) Loudspeaker (1) Shock absorbers (4) Car stereo (4) Battery (6) Air Vents (1) Arm (1) Spark plugs (2) Bodywork (2) Key (13) V-belt (4) -board computer (9) Checks and maintenance (12) Dashboard (3) Side indicator light (1) Headlight (8) Tail light (1) Fog lights (1) Air filter (7) Cabin air filter (7) Diesel filter (1) Grille (2) Injectors (2) Accessory Kit (1) Light bulb (3) Side turn signal light bulb (1) Headlight bulb (5) Rear light bulb (4) Interior lights ceiling light bulb (1) License plate light (2) Third brake light (1) Handle (2) Starter motor (1) Gear oil (2) Engine oil (7) Door panel (5) Windshield (1) Front bumper (1) Rear bumper (2) Brake pads (6) Pump (1) Fuel pump (1) Push button (1) Window lift button (1) Instrument cluster (8) Passenger compartment heating radiator (1) Wheel (2) Fuse box (9) Seat (2) Drive shaft (1) Crankshaft RPM sensor (2) Suspensions (1) Outside rearview mirror (4) Windscreen wipers (2) Windshield washer nozzle (1) Valve (1) Interior blower (4)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos