Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. RAM
    3. :
  3. Ram 3500
    4. : Petrol filter

RAM 3500 - Petrol filter

RAM 3500 (2019-2024 / DT, MK 5)
How to replace fuel filter on Ram 3500 [USA]
Place the car on the bridge, the filter is located approximately in the center of the floor above the transmission. Using a socket wrench, unscrew the nut on …read all…
Posted on 15 October 2022 by ScegliAuto
RAM 3500 (2019-2024 / DT, MK 5)
How do I replace the fuel filter on the Dodge RAM 3500?
There are two fuel filters in the Dodge RAM 3500, so replacement will need to be done twice. The first filter will be located inside the engine compartment, …read all…
Posted on 3 April 2024 by ScegliAuto
RAM 3500 (2019-2024 / DT, MK 5)
How to replace the fuel filter in the Dodge RAM 3500
Replacing the petrol filter periodically allows you to preserve the optimum health of the engine and its performance. The necessary operations are simple and …read all…
Posted on 1 April 2024 by ScegliAuto
Shock absorbers (1) Car stereo (2) Battery (3) Key (6) -board computer (6) Checks and maintenance (5) Brake discs (5) Headlight (6) Tail light (3) Fog lights (1) Air filter (5) Cabin air filter (3) Petrol filter (3) Diesel filter (2) Clutch (1) Light bulb (1) Side turn signal light bulb (1) Headlight bulb (3) Rear light bulb (1) Gear oil (1) Engine oil (7) Brake pads (2) Pump (1) Door (1) Instrument cluster (2) Wheel (1) Fuse box (5) Outside rearview mirror (1) Windscreen wipers (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos