Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. RAM
    3. :
  3. Ram 3500
    4. : Tail light

RAM 3500 - Tail light

RAM 3500 (2009-2019 / MK 4, DS, DJ)
How to remove the rear light assembly of the RAM 3500 [USA]
To proceed with the disassembly of the rear light unit of the RAM 3500 it is necessary to follow the following procedure: first of all unhook the support cable …read all…
Posted on 25 April 2024 by ScegliAuto
RAM 3500 (2019-2024 / DT, MK 5)
How to remove the rear light in the RAM 3500 pick-up?
As we can see in this tutorial, disassembling the rear light in the RAM 3500 pickup is very simple. We can do this in case we need to replace a faulty bulb or …read all…
Posted on 12 April 2024 by ScegliAuto
RAM 3500 (2009-2019 / MK 4, DS, DJ)
How to replace Dodge RAM 3500 low beam and fog light bulbs
To change the headlight lights of the Dodge RAM 3500 we start by raising the bonnet, remove the 3 screws that hold the headlight (2 to the side and 1 under the …read all…
Posted on 1 April 2024 by ScegliAuto
Shock absorbers (1) Car stereo (2) Battery (3) Key (6) -board computer (6) Checks and maintenance (5) Brake discs (5) Headlight (6) Tail light (3) Fog lights (1) Air filter (5) Cabin air filter (3) Petrol filter (3) Diesel filter (2) Clutch (1) Light bulb (1) Side turn signal light bulb (1) Headlight bulb (3) Rear light bulb (1) Gear oil (1) Engine oil (7) Brake pads (2) Pump (1) Door (1) Instrument cluster (2) Wheel (1) Fuse box (5) Outside rearview mirror (1) Windscreen wipers (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos